Restarting <interface>-cfg.service may cause the interface's IP
addresses to be flushed. If the default gateway goes through that
interface, then the default gateway is deleted. So we need to
restart network-setup.target.
This allows setting the max tcp window size for the route of
the default gateway (usually the internet access).
It works only for non-DHCP configurations by now.
Thus
networking.interfaces = [ { name = "eth0"; ipAddress = "192.168.15.1"; } ];
can now be written as
networking.interfaces.eth0.ipAddress = "192.168.15.1";
The old notation still works though.
‘systemd-vconsole-setup’ by default operates on /dev/tty0, the
currently active tty. Since it puts /dev/tty0 in Unicode or ASCII
mode, if the X server is currently active when it runs, keys such as
Alt-F4 won't reach the X server anymore. So use /dev/tty1 instead.
Flushing is bad if the Nix store is on a remote filesystem accessed
over that interface.
http://hydra.nixos.org/build/3184162
Also added a interface option ‘prefixLength’ as a better alternative
to ‘subnetMask’.
Instead it's enough to depend on
sys-subsystem-net-devices-<interface>.device, which in turn has a
"wants" dependency on the service (if any) that creates the interface.
For each statically configured interface, we now create a unit
‘<interface>-cfg.service’ which gets started as soon as the network
device comes up. Similarly, each bridge defined in
‘networking.bridges’ and virtual interface in ‘networking.interfaces’
is created by a service ‘<interface>.service’.
So if we have
networking.bridges.br0.interfaces = [ "eth0" "eth1" ];
networking.interfaces =
[ { name = "br0";
ipAddress = "192.168.1.1";
}
];
then there will be a unit ‘br0.service’ that depends on
‘sys-subsystem-net-devices-eth0.device’ and
‘sys-subsystem-net-devices-eth1.device’, and a unit ‘br0-cfg.service’
that depends on ‘sys-subsystem-net-devices-br0.device’.
It specifies what mingetty will be stopped, if a bad filesystem
triggers an emergency shell.
That should be ttyS0 on headless systems, and in that case,
nixos should stop the ttyS0 mingetty from getting in.
If passno is set, then systemd will instantiate a systemd-fsck unit,
which in turn will instantiate a <device>.device unit
(e.g. "none.device"). Since no such device exists, mounting will
fail. So don't set passno.
proxy_arp (and proxy_ndp for ipv6) can be turned on on a few
interfaces (at least 2).
This is mainly useful for creating pseudo-bridges between a real
interface and a virtual network such as VPN or a virtual machine for
interfaces that don't support real bridging (most wlan interfaces).
As ARP proxying acts slightly above the link-layer, below-ip traffic
isn't bridged, so things like DHCP won't work. The advantage above
using NAT lies in the fact that no IP addresses are shared, so all
hosts are reachable/routeable.
Systemd's systemd-vconsole-setup.service reads locale and console
font/keymap settings from these files. In particular, it sets the
virtual console to UTF-8 mode depending on the LANG setting.
This removed the need for the kbd job.
the device has no filesystem yet. Useful in Charon deployments.
The check for an uninitialised filesystem is kind of shaky now.
svn path=/nixos/trunk/; revision=34133
